Innokin SENSIS Pod Mod Kit | 40W 3000mAh

Innokin SENSIS Pod Mod Vape Kit

The Innokin Sensis Pod System is a really attractive gadget. It’s a good size, with a comfortable form, leather inlays, and a lovely two-tone color scheme. It combines a number of characteristics that can be found on a variety of other devices and merges them into a single product. Full panel fire button, variable airflow adjustment, and similar overall design to Geekvape with its leather grip.

The Sensis Pod Mod is not just attractive, but it also boasts some very impressive specifications. It includes a 3ml Glass pod tank, as well as a 3000mah internal battery with quick charge capabilities and a USB Type-C charging connection. Glass allows for a cleaner vaping experience. It also comes with a bright display and screen, adjustable airflow, and a 40 Watt power cap, all in one compact gadget.

Design

The Innokin Sensis Pod Mod Body is primarily composed of Zinc Alloy in a C-frame form, with a leather heel and trim work that gives it a manly futuristic vibe. It’s a well-made product that shows no indications of wear and appears to be fairly durable, even when dropped.

The vape pod has a full panel button on the front for simple firing and a full-color display and adjustable controls below it. This is great since you don’t have to look for a button to fire it; simply grasp the gadget in your hand and squeeze.

Pod Tank

This Pod can store 3ml of e-liquid, which isn’t much, but it’s adequate. A 510 drip tip manufactured of Delrin is included. The Innokin Sensis Pod Mod tank has a recess is located on the top, with a magnet ring connection within and three power connections in the center that power the coil. The airflow control slider is located below, and it opens vents in the side slots, enabling air to enter the chamber underneath the Pod.

Airflow

The airflow on the Innokin Sensis Pod Mod may be adjusted through a slider on the rear of the device. This opens up vents within the side holes and allows air to flow up through the Pod’s base. It’s a fantastic airflow adjustment that does a fantastic job of providing anything from a tight MTL vape to a limited DTL airflow.

The pod mod is charged through a USB Type-C charging connector beneath the front panel, which allows you to charge it while standing up and has a rapid charge rate of 5V at 1.7 Amps.

Coils

Innokin S Coil 0.25ohm (pre-installed)

The suggested power for this coil is 25-35W, and it remains very close to that. It’s made for a more limited DTL vape also known as RDL (Restricted Direct Lung Hitting). This coil gives a great thick vapor with a pleasant flavor. The more airflow you have, the less flavor you’ll receive, however, you can simply reduce it using the adjustable airflow slider.
Note that the closer you go to the 35 Watt limit, the dryer the vape becomes, so proceed with caution. The 35 Watt maximum is recommended especially with thicker vape juices.

Innokin Sceptre S Coil 0.65ohm

This coil is meant to be a Mouth to Lung coil, with a suggested wattage of 9-12W.  Using the maximum suggested watts and a very tight airflow is the best way to go. However, be aware that running it for an extended length of time with a high drag may reduce the coil’s lifespan. Dropping the wattage any lower results in a loss of flavor and a very cool vape.

Specifications

• Innokin Scepter-S Coil Series
• Low Resistance Protection
• 0.65ohm Scepter-S Coil
• Bottom Fill System – Silicone Stoppered
• Overheat Protection
• Bonus F0 Mode – Unlocked by Code or Vaping Over Time
• Wattage Mode
• 0.25ohm Scepter-S Coil
• Vaping Overtime Protection
• Press Fit Coil Installation
• Wattage Output Range: 6-40W
• Magnetic Pod Connection
• 3.1mL Glass Pod Capacity
• Voltage Mode
• Low Battery Protection
• Dimensions – 121mm by 40mm by 30mm
• Short-Circuit Protection
• Resistance Range:
• Zinc-Alloy Chassis Construction
• Integrated 3000mAh Rechargeable Battery
• Voltage Output Range:
• Type-C Charging Port

Package Includes

• 1 x MTL Drip Tip
• 1 x 0.65ohm Scepter-S Coil
• 2 x O-Rings
• 1 x Coil Connector
• 1 x 0.25ohm Scepter-S Coil
• 1 x 3.1mL Sensis Cartridge
• 1 x Innokin Sensis Pod Mod | Starter  Kit
• 1 x Type-C Cable
• 1 x 510 Adapter

VR: :metax:nodesc:ppc6: xnipsGaragevape xline03202021 :Linkrefresh005222021: saspricerefresh005222021